-
By bea alvarez
- Posted On July 18, 2011
- BY Gavin Susalski
The Light Flash!!!!!!!
OK. So I’ve been working on this all day. The Light Flash. Not Flashlight, Light Flash. It uses 3 1.5v batteries to make one 4.5v battery. It is an open circuit. When you complete the circuit the red LED will light up. It is in a small cardboard cas...
- Posted On July 19, 2011
- BY Gavin Susalski
Opening up a 2004 4th generation iPod Classic
I never thought that it would be so hard to open up an iPod. Apparently it has a seal on the cracks and the top half has clips that connect it to the bottom half. I was trying to fix the classic because the select button was jammed open. After I pried it ...
- Posted On July 19, 2011
- BY Gavin Susalski
The Light Flash Mini!!!!!!!!
OK. I have now invented the Light Flash Mini!! It is smaller and more portable than the Light Flash. It now comes in the color Magenta. It has the same design and light power as the Light Flash but it is just smaller.
- Posted On July 19, 2011
- BY Gavin Susalski
I’m saying hi to the world
I’m saying hi to the world. Hello everyone. Hi, how is it going? I’m fine. What about you? Please respond everyone.
- Posted On July 20, 2011
- BY Gavin Susalski
Vibrational Robots
Yesterday, I made vibrational robots with Ben, Katerina, Nicolas, and I. They were a fan that lit up and it was run on a 9v battery. Then we put highlighters on it with rubber bands. After that we cut off 3 of the blades on the fan to make it wobble. Fi...
- Posted On July 20, 2011
- BY Gavin Susalski
opening a computer
Yesterday we also opened up a computer. It was an old Dell Windows XP. We opened it up and took off the top. Inside we saw the mother board, a fan, the power box, and lots of wires. We had to pry everything open with a screwdriver. We are going to use the...
- Posted On July 21, 2011
- BY Gavin Susalski
Trying to defy the laws of physics
Well, yesterday I made a little sort-of hover craft thing. It was a piece of printer on top of part of a headphone. It had a wheel in the front too. I tried to make it move with a sail. There was a fan that was covered by a piece of paper or “sail&#...
- Posted On July 22, 2011
- BY Gavin Susalski
Lizard walking thing "robot"
Today is my last day of DIY Robotics. Today we built a Lizard Walking Thing “Robot”. It has 3 servos, 1 battery pack, and 1 arduino lilly pad. It was suposed to walk like a lizard but it had a bug in it so it didn’t work very well. We us...